PRODUCTIVE SERVICES

The Plastics Training Specialists

Plastics Manufacturing Q&A

Plastics Manufacturing Q&A

Feed

13/05/2016

How much back pressure is too much...?

The screw does most of the melting, but the barrel temperature should be maintaining the melt temperature. Question: How do I know if there is too much back pressure? My Response: The quick method is...   More


13/05/2016

Pressure Setting during mould Open & Close

The molding machine does it's best to achieve the set mold open and close speed as long as there is enough pressure available. Question: What is the pressure and speed relation for clamp open and close?...   More


20/04/2016

Watch your Back Pressure...

The fun of molding PP is that it can take a significant amount of abuse during molding and end use, but only if it has been melted properly. Concern: In the past week, two different customers consulted us...   More


02/04/2016

Burn Marks & Weld Line Issues

It is always critical to check your first stage short shot since it affects both mold filling and part packing. Request: Please provide reasons & remedies of burn-mark or weld line problems in plastic...   More


03/02/2016

Understanding Hydrolysis

I was discussing material dying with a technician and was asked this question... Bob What is Hydrolysis? I looked it up online, but I don't understand the technical jargon. My Response Basically,...   More


<< NewerOlder >>




Do you have your own Plastics Manufacturing issue you just can't seem to get right? 

 

Maybe we can help, send us your questions below.